User's Manual Part 1

13,56 MHz Multitag Reader Module, Version 0.9v
ACG Identification Technologies AT Page 21
5.3.3.3.6 Single shot (default 0)
If set the reader displays the serial number of a tag only once within a specified
timeout. The time out is defined at EEPROM register 0Fh. 00h indicated no delay.
The delay time can be adjusted stepwise in 100 msec steps.
5.3.3.3.7 Page read (default 0)
If set the reader sends the content of a page specified at EEPROM register 11h
instead of the serial number. Additionally the reader device reads following pages
defined at EEPROM register 12h.
5.3.3.3.8 Extend ID (default 0)
If set Tagit® and ISO14443 Type B cards returns additional information.
Tag type Number of
Bytes
Description
Tagit® 2 page size, number of pages
ISO14443B 7 application data, Protocol Identifier
Figure 5-7: Extended ID
5.3.3.4 Baud rate (0Ch)
The baud rate register defines the communication speed of the reader device.
Default value is 00h.
Baud rate register
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
RFU RFU RFU RFU RFU RFU BS1 BS0
Figure 5-8: Baud rate register
This register defines the baud rate of the device.
BS1 BS0 Baud rate
0 0 9600 baud (default)
0 1 19200 baud
1 0 38400 baud
1 1 57600 baud
Figure 5-9: Baud rate settings