Specifications

72
Check if the PC lights are ON.
If the lights are on then it appears that the Photobooth is working but the monitor is not.
Next steps:
When you turn ON the Photobooth, can you see any message on the screen? (ex; manu-
facturer name, or “NO SIGNAL”)?
If this is the case, the VGA cable is probably unplugged or damaged.
But if nothing appears on the screen (when you turn ON the Photobooth), please check if
there is power to the Monitor. Power cable is probably unplugged from the monitor.
Lights are ON
11.9 NO SIGNAL
11.10 CONTROL BOARD ERROR
The control Board is the green board located behind the PC. It doesn’t mean that the
Control Board is bad, it could mean that the PC could not connect with the Control
Board (because the Serial cable is not correctly connected).
Check following points:
1· Check the Control Board Serial Connection. (That is the common problem Point).
(attached 2 pictures: Correct and Error “Please Wait”). This connection is very easy to
lose during transport, or when we work at that area.
2· If all connections are good, then check that the Control Board Red LED is ON.
3· If all the 2 points are OK, but still doesn’t work, please send the Control Board to Digital
Centre (contact the Support Team before send it)
Red LED is ON