Specifications

65
To Update the Machine or change the software version, please follow these steps:
1· Open the DVD Driver.
2· Insert the “Boot DVD”.
3· Plug Off the Machine.
4· Plug On the Machine after 10 seconds.
5· Wait while the restore program reinstalls the
software (a progress bar appears on the screen).
The time process is about 30 minutes
6· A black screen appears when the process nishes.
7· Extract the DVD disk.
8· Plug Off the Machine.
9· Plug On the Machine after 10 seconds.
(In case that the Restore Program does not start automatically and
shows the message “Extract the dvd” immediately, then go to the
“Run the Restore Program Manually” (At the end of this Manual).
CUSTOMIZED FRAMES:
If you have customized frames and/or logos now is the time to upload.
1· Install the “Customized Frames DVD” into the DVD driver (CD or USB too).
2· Plug Off the Machine.
3· Plug On the Machine after 10 seconds.
4· When the software is working in Demo, then go into the SETUP MENU, by
pressing the Yellow button at the Setup Control Panel. It will read the customized
frames and/or logos automatically before the software start.
5· Be sure to select LOGO=YES and the correct frames and Wait for the Setup Menu
save all changes. (Wait for the “Shut Down Please” message on the screen).
6· When the software runs in Demo again, you can extract the DVD, CD or USB,
and keep it to a safe place.
The NEW FRAMES are now working; you can go to Setup Menu and adjust the
Date at the correct position.
11.3 BOOT DVD