Specifications

26
2· Remove the ink cassette.
Push down the ink cassette as
shown by the arrow 1 and pull it
out.
4· Cut off the defective part of the print paper
with scissors.
NOTE
Make sure to cut off the printed part of the print
paper. Failure to do this may result in the ink ribbon
sticking to the print paper and being torn.
5· Install the print paper and the ink cassette with
the ink ribbon.
6· Push the center of the door to close.
The print paper setting is initialized two minutes af-
ter you close the door.
When the auto feed & cut mode has been selec-
ted, the FEED & CUT procedure is repeated three
times after you close the door. When the print pa-
per with the postcard printing on its reverse side is
installed, the FEED & CUT procedure is repeated
ve times.
3· Take out the print paper.
When taking the print paper
out, pull it up toward you.