Specifications

Before Operation

2· Push the ink cassette toward the back of the unit.

Hold the handle of the ink cassette and push it straight toward the back of the unit.

Then raise it until you hear a click to secure it in the ink cassette holder.

NOTE

If the ink ribbon is used up, repeat the steps 1 and 2 to replace the print paper and the

ink ribbon.

Thermal head (Inside)

3· Push the center of the door to close.

The print paper setting is initialized two minutes after you close the door.

When the auto feed & cut mode has been selected, the FEED & CUT procedure is repeated

three times after you close the door. When the print paper with the post card printing on its

reverse side is installed, the FEED & CUT procedure is repeated ve times.

NOTE

· When closing the door, push it until a click is heard.

· If the PAPER/INK RIBBON indicator illuminates when the door is closed, the print paper

may have not been installed correctly.

In this case, open the door to make sure that the print paper has been installed

correctly. Then close the door again.

· On the auto feed & cut mode, when the print paper is installed more than three times,

the print paper may be used up earlier than the ink ribbon.