Owner's Manual

26
2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT
place jumper caps over these headers and connectors. Plac-
ing jumper caps over the headers and connectors will cause
permanent damage to the motherboard!
USB 2.0 Headers
(9-pin USB4_5)
(see p.14, No. 20)
(9-pin USB6_7)
(see p.14, No. 7)
(4-pin USB8)
(see p.14, No. 3)
Besides two default USB 2.0
ports on the I/O panel, there
are three USB 2.0 headers
and one USB port on this
motherboard. Each USB
2.0 header can support two
USB 2.0 ports.
USB 3.0 Header
(19-pin USB3_0_1)
(see p.14, No. 9)
Besides two default USB 3.0
ports on the I/O panel, there
is one USB 3.0 header on
this motherboard. The USB
3.0 header can support two
USB 2.0 ports.
Consumer Infrared
Module Header
(7-pin CIR1)
(see p.14, No. 5)
This header can be used
to connect the remote
controller receiver.
1
GND
Learn-in
IRTX
+5VA
LED
+5VA
CIR input