User manual

2020
2020
20
USB 2.0 Headers Besides five default USB 2.0
(9-pin USB10_11) ports on the I/O panel, there are
(see p.11 No. 19) three USB 2.0 headers on this
motherboard. Each USB 2.0
header can support two USB
2.0 ports.
(9-pin USB8_9)
(see p.11 No. 18)
(9-pin USB6_7)
(see p.11 No. 16)
1
USB_PWR
P-8
GND
DUMMY
USB_PWR
P+8
GND
P-9
P+9
1
USB_ P WR
P-10
GND
DUMMY
USB_ P WR
P +10
GND
P-11
P +11
2.8 Onboard Headers and Connectors2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA (SATA) Either end of the SATA data cable
Data Cable can be connected to the SATA /
(Optional) SATAII hard disk or the SATAII
connector on this motherboard.
USB_ P WR
USB_ P WR
P +7
P-7
P +6
P-6
GND
GND
DUMMY
1
Serial ATAII Connectors These five Serial ATAII (SATAII)
(SATAII_1 (Port 0): see p.11, No. 9) connectors support SATA data
(SATAII_2 (Port 1): see p.11, No. 8) cables for internal storage
(SATAII_3 (Port 2): see p.11, No. 10) devices. The current SATAII
(SATAII_4 (Port 3): see p.11, No. 11) interface allows up to 3.0 Gb/s
(SATAII_5 (Port 4): see p.11, No. 12) data transfer rate.
SATAII_5 SATAII_3 SATAII_1 (Port 4) (Port 2) (Port 0)
SATAII_4 SATAII_2 (Port 3) (Port 1)