Qiifck I n s t a l l a t i o n G u i d e Pro / G Y - P r o Series Espanol Русский
Copyright Notice: No part of this installation guide may be reproduced, transcribed, transmitted, or translated in any language, in any form or by any means, except duplication of documentation by the purchaser for backup purpose, without written consent of ASRock Inc.
Motherboard Layout ( G Pro ) 25 rn (Q со" IS 2 17 13
Motherboard Layout ( GV Pro ) w D> С Ш 3 19II
1. Introduction Thank you for purchasing ASRock G Pro/GV Pro motherboard, a reliable motherboard produced under ASRock's consistently stringent quality control. It delivers excellent performance with robust design conforming to ASRock's commitment to quality and endurance. This Quick Installation Guide contains introduction of the motherboard and step-bystep installation guide for new DIY system builders.
compliance wake up events; supports jumperfree; SMBIOS 2.3.1 support; CPU irequency stepless control (only for advanced users' reference) OS: Windows 98SE / ME / 2000 / XP compliant While CPU overheat is detected, the system will automatically shutdown and the power button on the chassis will be disabled. Please check if the CPU fan on the motherboard functions properly before you resume the system.
(black) and 184-pin DDR DIMM (blue) can be easily distinguished by the fool-proof design. Please do not insert both 168-pin SDRAM DIMM and 184-pin DDR DIMM at the same time. Only use one single type of DIMMs at one time. To optimize the compatibility it is not recommended to use two different models of the DIMMs at the same time. Installing a DIMM Step 1. Unlock a DIMM slot by pressing the retaining clips outward. Step 2.
Jumper Setting PS2JJSB_PWR1 2 1 (see p.2/p.3 item 22) Description 2_3 Short pin2, pin3 to enable gj|g| • [o T oj +5VSB (standby) for PS/2 or + 5V +5VSB U® 5 wake up events. Note: To enable +5VSB, it requires 2 Amp and higher standby current. D i s c o n n e c t the power CLRCMOS1 cord, then short the sol- (see p.2/p.3 item 17) Solder points der points to clear CMOS by using metal material, eg., a paper clip. 2.5 Connectors Connectors are NOT jumpers.
Internal audio connectors These connectors allow you (4-pin CD1, 4-pin AUX1) CD-,: GtlD GND -CD-L AUX-R GND GND AUX-L (CD1: see p.2/p.3 item 24) (AUX1: see p.2/p.3 item 23) AUX1 CD1 to receive stereo audio input from sound sources such as a CD-ROM, DVD-ROM, TV tuner, or MPEG card. ВАС 'CUI-R iBACKC . f-L Audiol connector (9-pin AUDI01) (see p.2/p.3 item 20) L This is an interface for the front panel audio cable that allows О . :-pc • i- 4 convenient connection and control of audio devices.
3. BIOS Information The Flash Memory on the motherboard stores BIOS Setup Utility, When you start up the computer, press during the Power-On-Self-Test (POST) to enter BIOS Setup Utility, otherwise, POST continues with its test routines. If you wish to enter BIOS Setup after POST, restart the system by pressing + + , or by pressing the reset button on the system chassis. You can also restart by turning the system off and then back on.
www.asrock.
