Installation guide

28
English
2.7 Jumper Setup
e illustration shows how jumpers are setup. When the jumper cap is placed on
the pins, the jumper is “Short”. If no jumper cap is placed on the pins, the jumper
is “Open”. e illustration shows a 3-pin jumper whose pin1 and pin2 are “Short”
when a jumper cap is placed on these 2 pins.
SATA DOM Power Jumper*
(3-pin SATAPWR1)
(No. 25)
SATA DOM SATA Cable (Default)
*SATAPWR1 allows you to select the internal voltage source for the SATA DOM
connected on the SATA_0 connector (No.24).
CPU PECI Mode Jumper
(3-pin PECI1)
(No. 44)
Reserved Only CPU PECI connect to BMC
(Default)