User guide

3.5.8 Network Bonding Configuration

This page is used to configure the network bonding configuration for network interfaces.

NOTE: A minimum of 2 network interfaces are required to enable Network bonding for the device.

Network Bonding

Check this option to enable network bonding for network interfaces.

NOTE: If VLAN is enabled for slave interfaces, then Bonding cannot be enabled. VLAN can be disabled

under Configuration -> Network -> VLAN.

Default Interfaces

Choose any one of the bonding interfaces for configuring active slave(s).

Auto Configuration

Enable this option to configure the interfaces in service configuration automatically.

NOTE: If Auto configuration is disabled, then interfaces in services can be configured via IPMI

command. If Auto configuration is enabled, then all the services will be restarted automatically.

Save

Click “Save” to save the current changes.

NOTE: Disabling bonding will disable the Bonding-VLAN configuration.

Reset

Click “Reset” to reset the modified changes.