Installation guide

2.5 Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is "Short". If no jumper cap
is placed on pins, the jumper is "Open". The
illustration shows a 3-pin jumper whose pin1
and pin2 are "Short" when jumper cap is
placed on these 2 pins.
Jumper Setting
PS2_USB_PWR1 ( 2 2_3 Short pin2, pin3 to enable
(seep.2 No. 1) ЩЩо] .. [fa.Ol +5VSB (standby) for PS/2
+5V +5VSB or USB wake up events.
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
Clear CMOS fFSTol
(CLRCM0S1,2-pin jumper) ^—>
(see p.2 No. 8) 2-pin jumper
Note: CLRCMOS1 allows you to clear the data in CMOS. The data in CMOS includes
system setup information such as system password, date, time, and system
setup parameters. To clear and reset the system parameters to default setup,
please turn off the computer and unplug the power cord from the power
supply. After waiting for 15 seconds, use a jumper cap to short 2 pins on
CLRCM0S1 for 5 seconds.
ОС 800 Jumper
(ОС 800,3-pin jumper, see p.2 No. 27)
Default
Note: If you want to overclock the FSB800-CPU (e.g. Cel400, E1 ООО, E2000, E4000,
E5000, E6000 series CPU) to FSB1066 on this motherboard, you need to
adjust the jumpers. Please short pin2, pin3. Otherwise, the CPU may not work
properly on this motherboard. Please refer to below jumper settings.
2_3
ГШ
AS Rock 945GCM-S Motherboard