Technical information

100 Chapter 3
7. Replace the three screws to secure the Speaker Modules.
8. Replace the speaker wire into the channel as shown.
Replacing the CPU (Alternate Procedure)
IMPORTANT:The CPU has a Pin1 locator that must be positioned corresponding to the marker on the CPU
socket
NOTE: Only use this procedure if you removed the thermal unit according to the instuctions given in
“Removing the CPU (Alternate Procedure)” on page 84.
IMPORTANT:Ensure all thermal pads are in place before replacing the Thermal Module.
The following thermal pads are approved for use:
• Silmore GP50
• Honeywell
• Jet Motor 7762
Step Size Quantity Screw Type
Speaker Module M2.5*2 x 6mm flat head 3