Quick Start Guide

1. Open your grill and remove the grates, radiant trays, and burners from the firebox area. Trellis and

U-burners are removed by lifting up the rear of the burner, and carefully twisting to clear the igniter

shroud. Infrared Sear Burners have a small metal cover over the igniter which must be removed first.

There is also a screw at the rear firebox wall which must be removed. The sear burner can then be

carefully removed using the same twisting action to avoid breaking the ceramic igniter. Remove the

outside rear cover of the grill. If your grill is mounted on a cart, remove the rear access panel of the

cart as well. Also remove the control knobs and drip pan.

CHANGING ORIFICES

SPUD

ORIFICE

LOCK-NUT

FLEX

HOSE

BURNER

BRACKET

ELBOW

2. Beginning with the Infrared Burner in the upper canopy area of the grill, access the spud orifice

shown in the image below. Disconnect the flex hose first. Then use a wrench to hold the brass

elbow steady, while using another wrench to remove the lock-nut. You may now remove the elbow

out of the burner bracket. Try not to disturb the flex hose connection by unduly bending it too

much. Be careful not to damage the wires and copper thermocouple tube nearby.