Operation Manual

EF1210 C
OMMAND
S
ET
R
EFERENCE
ASPI Digital - The Sound of DSP Technical Support: 404.892.3200 83
PONG -
DEVICE RESPONSE TO
PING
COMMAND
The PONG message is sent by the EF1210 in response to a PING command. This can
be used by the remote control device to find out what device IDs are used by
EF1210s. Also, see the PING command.
Remote Commands
The EF1210 will not recognize the PONG command. You should only send the PING
command from a remote control device.
EF1210 Messages
The following message is sent by the EF1210 when the remote control device sends it
a PING command.
Example
In the following example, the remote control device sends the PING command to find
out what EF devices are on the bus. One EF1210 and one EF200 returns a PONG
message to announce their presence. Acknowledgment mode is enabled.
EF1210 Message Message meaning
PONG Response from EF device.
Remote Command EF1210 Message
C**PING C06PONG
A17PONG