Operation Manual

EF1210 C
OMMAND
S
ET
R
EFERENCE
ASPI Digital - The Sound of DSP Technical Support: 404.892.3200 79
SELECTR
C
-
SET FRONT PANEL
REMOTE
METER TO DISPLAY REMOTE INPUT CHANNEL
c
The SELECTR
c
command sets the front panel R
EMOTE
meter to display reference
input channel c of the EF1210.
The factory default setting for SELECTRc is A (Reference A).
Remote Commands
The following commands can be sent by the remote control device to set the front
panel R
EMOTE
meter to display reference input channel c.l
EF1210 Messages
The following messages are sent by the EF1210 in response to a SELECTR? com-
mand, or in response to any SELECTR
c
command when acknowledgment mode is
on.
Example
In the following example, the remote control device requests the current reference
channel displayed on the R
EMOTE
meter of the EF1210 with Device ID number 7.
Then it sets channel 5 to be displayed on the R
EMOTE
meter of the same EF1210.
Acknowledgment mode is enabled.
Remote Command Effects
SELECTR
c
Set front panel R
EMOTE
meter to display reference
input channel c.
c is either A or B.
SELECTR? Request current assignment of front panel R
EMOTE
meter.
EF1210 Message Message meaning
SELECTR
c
Front panel R
EMOTE
meter is currently set to dis-
play reference input channel c.
Remote Command EF1210 Message
C07SELECTR? C07SELECTR1
C07SELECTR5 C07SELECTR5