Operation Manual

EF1210 C
OMMAND
S
ET
R
EFERENCE
ASPI Digital - The Sound of DSP Technical Support: 404.892.3200 75
RESETF -
RESTORE ALL SETTINGS TO FACTORY DEFAULT
The RESETF command causes all the EF1210 settings to be restored to the factory
default. This command does not save the settings to non-volatile memory, but you
can follow the RESETF command with a SAVENV command to do this. The vari-
ables that are restored as a result of this command are listed at the end of this section.
Refer to “Default Values and Saved Parameter List” on page 84
Remote Commands
The following command can be sent by the remote control device to restore the
EF1210 to the factory defaults.
EF1210 Messages
The EF1210 sends a RESETF message in response to a command, after it sends status
messages for each of the settings that were changed by the restore operation, if
acknowledgment mode is enabled.
Example
In the following example, the remote control device restores the factory default set-
tings of the EF1210 with Device ID number 12. The EF1210 sends back messages
notifying the remote control device that the parameters have been reset to the factory
standards.
Remote Command Effects
RESETF Change all the settings back to their factory
defaults.
EF1210 Message Message meaning
RESETF The EF1210 has finished restoring the factory
defaults.
Remote Command EF1210 Message
C12RESETF C12RESETF