Operation Manual

EF1210 U
SER
M
ANUAL
68 http://www.aspi.com Copyright © 1999, All Rights Reserved
GAINZ
C
-
SET
ZONE
OUTPUT GAIN ON OUTPUT
C
The GAINZ
c
command sets the Z
ONE
output gain level on output c of the EF1210 to
a level between 0 dB and 20 dB. The output gain setting corresponds to a nominal
output level that ranges from -20 dBu to 0 dBu, respectively. For instance, setting
GAINZ
c
to 0 makes the nominal output level -20 dBu, and setting GAINZ
c
to 20
makes the nominal output level 0 dBu.
The factory default setting for GAINZ
c
is 12 (-8 dBu = -10 dBV).
Remote Commands
The following commands can be sent by the remote control device to set the Z
ONE
output gain level.
EF1210 Messages
The following messages are sent by the EF1210 in response to a GAINZ
c ? com-
mand, or in response to any GAINZ
c
command when acknowledgment mode is on.
Example
In the following example, the remote control device requests the current Z
ONE
input
gain on output A of the EF1210 with Device ID number 7. Then it sets a new level on
output A on the same EF1210. Acknowledgment mode is enabled.
Remote Command Effects
GAINZ
c x Set Z
ONE
input gain on output c.
c is either A or B.
x ranges from 0 dB to 20 dB.
GAINZ
c ? Request current Z
ONE
output gain on output c.
Note.
The wildcard character (*) is not allowed for specifying the chan-
nel number c for the GAINZc command.
EF1210 Message Message meaning
GAINZ
c x Z
ONE
output gain on output c is currently x dB.
Remote Command EF1210 Message
C07GAINZA? C07GAINZA0
C07GAINZA19 C07GAINZA19