Operation Manual

EF1210 U

SER

ANUAL

GAINC -

SET

CODEC

OUTPUT

GAIN

The GAINC command sets the CODEC output gain level of the EF1210 to a level

between 0 dB and 20 dB. The output gain setting corresponds to a nominal output

level that ranges from -20 dBu to 0 dBu, respectively.

The factory default setting for GAINC is 12 (-8 dBu = -10 dBV).

Remote Commands

The following commands can be sent by the remote control device to set the CODEC

output gain level.

EF1210 Messages

The following messages are sent by the EF1210 in response to a GAINC? command,

or in response to any GAINC command when acknowledgment mode is on.

Example

In the following example, the remote control device requests the current CODEC out-

put gain of the EF1210 with Device ID number 7. Then it sets a new level on the

same EF1210. Acknowledgment mode is enabled.

Remote Command Effects

GAINCx Set CODEC output gain.

x ranges from 0 dB to 20 dB.

GAINC? Request current CODEC output gain.

EF1210 Message Message meaning

GAINCx CODEC output gain is currently x dB.

Remote Command EF1210 Message

C07GAINC? C07GAINC0

C07GAINC4 C07GAINC4