Operation Manual
EF1210 U
SER
M
ANUAL
36 http://www.aspi.com Copyright © 1999, All Rights Reserved
M
OUNTING
THE
EF1210
The EF1210 can be mounted in a rack enclosure using four large screws (10-32 x 1/
2”) included with the unit. One EF1210 fits in a single rack space.
Recommendation
For Easy Access
While not required, it is prudent to leave a single rack space in between the EF1210
and other units in your rack. This not only is a good design practice, but also gives
you easier access to the backpanel. If you cannot leave a single rack space, mount the
EF1210 below units that are longer in length so that you can access the Phoenix con-
nectors on the backpanel more easily.
Instructions for
Securing Power
Supply to Back of
EF1210
• Locate the cable clamp on the back panel of the EF1210 above the RS-232 port.
• Remove the screw and thread the power cord through the cable clamp.
• Attach the cable clamp to the back panel of the EF1210 and tighten the screw.
Align the clamp so that the power cable does not interfere with the connectors on
the EF1210 backpanel.
• Plug in the power supply.
• We recommend that you also Ty-wrap the power supply to the rack.
The purpose of securing the power supply to the back panel is so that if the power
supply were to drop, it would pull where the cord is attached with the cable clamp and
not pull the plug out of the EF1210.
Figure 16. Attaching a cable clamp to the back panel of the EF1210
Thread power cable through cable clamp and attach to
EF1210 back panel for strain relief on the power supply.
REMOTE CONTROLREMOTE CONTROL
ASPI BUS IN
ASPI BUS OUT
RS-232
L
INE
L
INE
L
INE
L
INE
L
INE
MIC/L
I
5, 15 VDC 5, 12 VDC
M
IC
1
P
HANTOM
1
M
IC
2
P
HANTOM
2
D
EVICE
ID 8
D
EVICE
ID 4
D
EVICE
ID 2
D
EVICE
ID 1
21
D
EVICE
ID 16
M
IC
3
P
HANTOM
3
M
IC
4
P
HANTOM
4
M
IC
5-8
P
HANTOM
5
P
HANTOM
6
P
HANTOM
7
P
HANTOM
8
435
R
ESERVED
R
ESERVED
PIN 2: TX
3: RX
ON
15
PIN 2: TXD
3: RXD