Operation Manual

A
DVANCED
I
NSTALLATION
ASPI Digital - The Sound of DSP Technical Support: 404.892.3200 17
Device ID
These switches set the Device ID for the EF1210. The ID can be any number from 0
to 31. It is a five bit binary number, with the least significant bit on switch 20. The
number after the “Device ID” label denotes the binary value of the switch. Table 2
lists the DIP switch positions necessary to set each Device ID number from 0 to 31.
The Device ID is the same ID that is used with the EF1210 Command Set. The
EF1210 will respond only to commands that are sent with the same Device ID as the
one set on its switches. If you set the Device ID to one that doesn’t agree with your
remote control commands, the remote control will no longer affect that particular
EF1210.
If you are not using a remote control device (via RS-232 or the ASPI Bus), the Device
ID settings do not matter. The default Device ID is 0.
Table 2: DIP Switch Positions for EF1210 Device IDs (Blank spaces mean switch is OFF)
Device ID Switch 16
(Device ID 16)
Switch 17
(Device ID 8)
Switch 18
(Device ID 4)
Switch 19
(Device ID 2)
Switch 20
(Device ID 1)
0 (default)
1 ON
2ON
3ONON
4ON
5ONON
6ONON
7ONONON
8ON
9ON ON
10 ON ON
11 ON ON ON
12 ON ON
13 ON ON ON
14 ON ON ON
15 ON ON ON ON
16 ON
17 ON ON
18 ON ON
19 ON ON ON
20 ON ON
21 ON ON ON