Operation Manual

EF1210 U
SER
M
ANUAL
A-20 http://www.aspi.com Copyright © 1999, All Rights Reserved
•E
NABLE
DTMF C
OMMANDS
. Enable/disable a series of built-in commands trig-
gered by DTMF digits. The built-in commands are listed in Table 8 below. All
commands start with the number 0 and end with a ‘#’ character. For each com-
mand, you specify a two digit command code plus a payload.
For example, to turn PRIVACY on, you would press 0PR1# (which corresponds
to 0771#). To turn noise suppression off, you would press 0NS0# (0670#).
•E
NABLE
P
ASSCODE
. Enable/disable a predefined passcode on incoming calls.
The passcode is currently hardwired to the digits that correspond to ASPI
(‘2774’).
•C
URRENT
U
SER
V
ALIDATED
(H
OLD
). Puts the caller on hold.
•C
LONE
M
E
! Copies EF200 settings of current EF200 to all EF200s connected
together via the ASPI Bus.
•S
AVE
S
ETTINGS
. Save settings to non-volatile memory.
•R
ESTORE
S
ETTINGS
. Restores setting from non-volatile memory.
Table 8: Built-in DTMF commands
C
ODE
C
OMMAND
N
AME
P
AYLOAD
O
PTIONS
AG AGC 0, 1, 2
GP GAINP *5, *4, *3,..., 0,..., 03, 04, 05
The ‘*’ character is used as a minus sign.
LE LEC 0, 1, 2
NS NS 0, 1, 2
NL NSL 06, 10
RM MUTER 0, 1, 2
PH MUTEP 0, 1, 2
RC REMCON 0, 1, 2
PR PRIVACY 0, 1, 2