Operation Manual

EF1210 U

SER

ANUAL

i. Adjust CODEC output level. Adjust it to -10 dBV (-8 dBu) or to 0dBu to match

the level required by your CODEC.

ii. Once you have completed T

CODEC calibration (you may have skipped this

step if you are not using playback and record), click on the Next button to pro-

ceed to Zone/Reference setup.

ALIBRATION

TEP

5: Z

ONE

EFERENCE

ETUP

For Calibration Step 5, the S

TEP

NDICATOR

will be lit in the fifth position.

During Calibration Step 5, you may set the EF1210 to use different AEC Reference

Inputs for each channel. The reference signal used with channel 1 will be used as

Zone A output, and the reference used with channel 8 will be used as Zone B output.

Microphones on the input channels must be placed in the sound field of the appropri-

ate Zone output for the EF1210 to operate correctly; otherwise echoes will not be can-

celled. In other words, if for example the microphone on channel 3 is in the

soundfield of the loudspeaker connected to the Zone B output, channel 3 must be con-

figured to use Reference B (AEC B) as its reference.

Note.

The CODEC output level is also adjustable from -20 dBu to 0 dBu

using the UP and DOWN arrows on EFPanel.

Figure 27.

Step 5: Zone/Reference Setup