User manual

MEX ASPERA-3
Ref.:
ME-ASP-MA-0002
Issue:
Issue 1 Rev. 4
Date:
15/2/2002
Page:
Page 28 of 58
ASPERA-3 EGSE User Manual
IFSI
CNR
3.1.3.1 SCOE internal
This first block of commands is used internally to the SCOE program. These commands are used to set
internal flags/variable (which remain constant up to the next setting) or check the telemetry data
(VERTM).
ID N. Par Param. Description
IMME
0 Follows immediate cmd
PROG
0 Follows program cmd
NORM
0 Follows normal cmd
ASAP
0 Same as NORM. For back-compatibility
EXP 0 Follows Experiment request commands. This is
normally an ASPERA request (event)
HEX
0 Follows parameters in Hex format (no 0x.. prefix
requested)
DEC
0 Follows parameters in Dec format
ACKA
1 Flg=0/1 Ack report on/off on acceptance of pkt
ACKE
1 Flg=0/1 Ack report on/off on execution of pkt
APID
1 61 - 65 App ID for pkt
NPAC
1 N Set to N the # pkt for current APID (it is auto
incremented)
INFO
1 N Set to N the SCOE local info (echo) level.
STATE
1 N Set to N the SCOE state machine level
VERHK
6 TO, Sid,
Offs,
Msk, Mn, Mx
This command is only valid in a procedure.
Halt scoe local procedure (with time out TO in
seconds) untill HK word do match the following
parameters:
TimeOut, SID, SourceDataOffset, Mask, Min, Max.
Offset is referred to SID position in HK packet (i.e. 8
words from beginning of packet.
ONLY FOR BACK COMPATIBILITY. Use VERTM