Installation Guide

G lue Down installation Continued

I nstalling The Floor

Spread the adhesive from the chalk line/straightedge out to approximately the width of two planks.

Install the first row of starter planks along the chalk line/straightedge and secure into position with the

tongue facing the starter wall. NOTE: Proper alignment is critical. Misaligned starter rows can cause

side and end gaps to appear in proceeding rows of flooring. When you have the starter rows complete,

you can begin the next row. When you are certain the first two starter rows are straight and secure,

spread adhesive 2 to 3 feet wide across the length of the room. Continue to install planks and push

them into place. Place the tongue of the board into the grooves of installed boards and press into the

adhesive. As you continue working across the floor try to maintain a 10” minimum space between end

joints. Randomly install different lengths to avoid a patterned appearance. NOTE: Never strike a

rubber mallet or hammer directly on the flooring to engage the tongue-and-groove. This practice can

damage the flooring and/or the finish. Remove excess adhesive from the surface of the installed

flooring as you work – this will help to save time and protect the finish. A damp rag with the

appropriate adhesive remover or mineral spirits will remove the excess adhesive. Frequently change

towels to avoid leaving a haze on the flooring surface. DO NOT use water to remove Urethane

adhesives from the flooring.

As you approach the end wall it may be necessary to cut the width of the last row – be sure to allow for

the expansion space along the end wall. Once the final cuts are made set planks into place. After the

installation is complete, remove the straight edge and glue down the first two boards. Restrict foot

traffic for a minimum of 6-8 hours and wait 24 hours before permitting moving of furniture onto the

floor. To remove excess adhesive that has dried, use the same glue remover but pay close attention not

to mar the finish from excessive rubbing.

Aspen Flooring prohibits the use of any adhesive tape on the flooring at any time during

installation or thereafter. This includes tapes that are specially made for wood flooring, such as

blue or green masking tapes. Such use of tape may void this Warranty and no claims will be

addressed in regards to defects in the finish as a result of the use of tape.

Final Inspection

After the floor has been cleaned, inspect the floor for nicks, scratches, gaps or planks that may have

moved during installation, as well as any other imperfections that need attention. Touch up nicks and

scratches with touch-up products. In typical climates, the new floor can accept foot traffic within 24

hours. In areas where additional curing time is required, more time may be needed.

CAUTION: Adhesive that is not properly removed and allowed to dry on the finish surface can

be difficult to remove and may leave a haze or residue. Use the proper cleaning method

recommended by the adhesive manufacturer and ensure ALL traces of glue are removed from

the surface.