Instructions / Assembly

N ail Down Installation

Additional Tools and Material Needed:

Drill

Tapping Block

Compressor w/air hose and in line regulator

Pneumatic Nailer/Stapler

Industry approved moisture vapor retarder such as Aquabar

NOTE: Our products are not warranted against squeaking, popping or crackling when using

staple-down or nail-down installation methods. Some squeaking, popping or crackling is normal

and possible when using staple-down or nail-down installation methods. These symptoms may be

aggravated in arid areas or during dry conditions.

S et Up and Use of Pneumatic Staplers and Nailers

Minor occasional noises within the flooring are inherent to all staple/nail-down installations and can

change as environmental changes occur. This is not a manufacturing defect and is therefore not covered

under our warranties. You can help reduce squeaking, popping, and crackling by being sure that the

subfloor is structurally sound, does not have any loose decking or joists, and is swept clean prior to

installation. You should also be sure that your stapler or nailer is setting the fastener properly, not

damaging the planks, and that you are using the correct nailing schedule. When used improperly, staples

or cleats can damage wood flooring. If the tool is not adjusted properly the staples/cleats may not be

positioned at the proper angle and cause blistering, peaking, squeaking, or crackling of the floor. Some

models may require the use of an adapter to adjust for proper thickness. Test the tool on a piece of scrap

material first - set the stapler/nailer flush on the tongue side of the plank and install a staple/cleat.

Should the staple/cleat penetrate too deeply reduce the air pressure; if the staple/cleat is not deep enough

then increase the air pressure using an in-line regulator. The crown of the staple/cleat should sit flush

within the nail pocket to prevent damage to the flooring and to reduce squeaking.

Aspen Flooring is not responsible for damage caused by the mechanical fasteners or staple guns.

Recommended Staples/Cleats for Aspen Flooring hardwood floors:

Engineered 3/8” .............. 20 gauge, 1” – 1-1/2” length

Engineered 1/2”–5/8” ..... .20-18 gauge, 1” – 1-1/2” length

Engineered 3/4” .............. 18 gauge, 1-1/2” length

Solid 3/4" ........................ 16 – 15.5 gauge, 1.5” – 2” length