Use and Care Manual

Product Name
Aspect Collage™ Decorative Tiles
OmniClass 2004: Table 22-09 30 29 –Tiling
Associated Specification Section
MasterFormat 1995: Section 09370 –Tile
MasterFormat 2004: Section 09 30 29 –Tiling
Manufacturer’s Name
Acoustic Ceiling Products, L.L.C.
May, 2020
PRODUCT DESCRIPTION
○ Composite tiles must be attached to a substrate such as primed drywall, plaster or clean, smooth
tile.
□ Note: primer and or paints should be allowed to cure for the recommended paint
supplier. Typically 25-30 days.
○ Care must be taken to avoid damaging the exposed surface finish during cutting.
○ For mechanical fastening materials, use only stainless steel, aluminum or plastic.
● SAFETY PRECAUTIONS
○ De-bur sharp edges after cutting with fine surfaced grit sand paper.
● AVAILABILITY
○ Nation wide
● COST
○ Varies with size of tile, substrate condition and configuration, and relative size of building.
○ Consult manufacturer's national or regional offices for specific product costs or relative costs.
PRODUCT PROPERTIES
● MATERIALS, COMPOSITION, AND PROPERTIES
○ Printed Laminate Composite and Aluminum:
■ Composite Printed laminate:
■ Core: composite
● ACCESSORIES
○ Adhesives:
■ PB-FSA High Performance Acrylic Adhesive recommended for peel and stick tile.
■ One-component, high strength construction adhesives, silicones and urethanes as
recommended by product manufacturer for panels.
○ Tape: Double sided foam tape with contact surfaces, as recommended by panel manufacturer.
○ Trim to finish wall edges; colors available to match most finishes.
● DIMENSIONS
○ Available Tile Thicknesses: Approximately 3mm (consult manufacture for thickness)
○ Tile Sizes:
□ 12 x 11.75 inches approximately (individual tiles)
□ 13.58 x 12.79 inches approximately (individual tiles)