Specification

Aspect Collage™ Decorative Tiles Section 09 30 29
Acoustic Ceiling Products, L.L.C. DECORATIVE METAL TILES
May, 2020 Page 4 of 4
MiniSPEC 09 30 29-4 DECORATIVE METAL TILES
3.5 INSTALLATION
A. Install adhesive and metal [s] [tiles] to manufacturer's written instructions and as follows:
[OR]
B. Apply from inside corner, working outwards and upwards.
C. For installation of s around a focal point, build out symmetrically from both sides of the
focal point.
D. For installation of tiles, peel backing from tile and align into correct position. Dispose of
slippery backing sheets as work progresses.
E. With a soft cloth, apply pressure evenly across [s] [tiles] to remove excess air.
F. Temporarily brace larger s using clamps or removable painter’s tape when using slow-
drying adhesives.
G. Following manufacturer's instructions, bend exposed edges after adhesive has set to
achieve desired finish.
H. Remove excess wet adhesive residue with damp sponge or cloth while still wet and
visible.
I. Wipe clean with dry cloth.
3.6 CLEANING
A. Section 01 74 00: Cleaning installed work.
B. Clean completed wall of excess adhesive, dust, dirt, and other contaminants.
C. Reinstall wall plates and accessories removed prior to work of this Section.
3.7 PROTECTION OF FINISHED WORK
A. Section 01 78 40: Protecting installed work.
B. Protect finished [s] [tile] from damage of other work.
3.8 SCHEDULES
END OF SECTION