Specification

A chop saw (motorized miter saw) is recommended for straight cuts. A jig saw or scroll saw is
recommended for non-straight cuts. For circular cuts, a hole saw works well. See Aspect Tile Installation
Guide for additional information. All cutting blades should be carbide-tipped or high-speed steel, and
made for cutting nonferrous metal. When cutting is complete, use a fine-grit sandpaper or a small metal
file to debur the cut edges. Take the cut tile to the work space and place it in its intended location and
make sure it fits properly. Alternative Option: A utility knife with a sharp blade can also be used for
straight cuts on the tiles. Measure and mark the tile where the cut must be made with a marker on the
protective film. Using a straight edge, score along the entire tile using a utility knife. Carefully make a
few passes with a bit more pressure each pass. Bend back and forth until tile separates.
How do I bend the tiles for inside or outside corners if I do not want a seam?
Inside corners usually look great when tiles are butted together. Outside corners can be hidden with our
Aspect Trims. If you would prefer to route and bend corners, please see this guide (PDF).
What should be used to clean the tiles?
Soap, water and soft cloth. A glass cleaner or grease cutter can also be used.
What should be used as a trim or an edge treatment?
We offer peel and stick edge trims in 9 colors. Otherwise, Aspect should be treated like any other tile.
Clear or colored caulk is a good option. Caulk can be painted to match wall color if preferred. Wood,
plastic or other types of trim also work well depending on your preference and abilities.
Can Aspect be applied to a working surface or to the floor?
These applications are not recommended, as the rubbing could potentially scratch the surface of the
tile.
What is the life expectancy of the Aspect Tile?
Aspect tiles and panels will last well-beyond the lifetime of your kitchen, bath or wall project. The tiles
and panels are virtually indestructible under normal use.
Does the surface of an Aspect tile scratch easily?
Not easily, but it can be scratched like any coated metal surface.
When starting a project, would I work from one side to the other, or from the
center out?