A Aspect" Glass Peel & Stick Tile Installation Guide PROPER SURFACE PREPARATION IS ESSENTIAL FOR A SUCCESSFUL PROJECT Failure to follow recommended surface ion instructions may void guaranty ACR LIC s imponderable for any labor costs or damaged product incurred as & result of improper Installation. All product defects are covered under our Year limited warranty. Read this installation manual in its entirety before you start.
Method 2: If you do not intend to prepare, sand and prime the surface, an additional adhesive should be used. We recommend a high-quality polyurethane construction adhesive be applied to the back of each tile in these cases. Be sure to remove the release film on the back of each tile before applying additional adhesive. Apply no more than about five pea-sized dots of adhesive to the back of a full tile (see right). Keep the adhesive a half-inch from the edges. Firmly press the tiles into place.
Measure the first area to be covered by Aspect material. We recommend you lay out the entire project on a flat surface, like a table or the floor, before installing to the substrate, to be sure you have enough tiles and your design is correct. As each project is different, be sure to plan for cutouts, corners or edge treatments before applying tiles. 1) Installing your first tile: Be sure the substrate is clean and dry. Remove the backing from the tile.
3) Install and/or cut remaining tiles . Install the next 10th 12 subsequent tiles by light tacking or pressing them on the wall. At this time verify that the tiles are lining up straight and square. If they are you can press on the tiles to secure them firmly to the wall. If some of the tiles have come out of alignment you can work backwards and “pop” the tiles off using a putty knife. Then reapply the tiles making small adjustments to each tile to regain alignment.
