Use and Care Manual

How should the tiles be cut if a full tile is not needed?
A chop saw (motorized miter saw) is recommended for straight cuts. A jig saw or scroll saw is
recommended for non-straight cuts. For circular cuts, a hole saw works well. See Aspect Tile
Installation Guide for additional information. All cutting blades must be fine-toothed “metal
cutting” type. When cutting is complete, use a fine-grit sandpaper or a small metal file to debur
the cut edges. Take the cut tile to the work space and place it in its intended location and make
sure it fits properly. Another cutting method is to use a router.
What should be used to clean the tiles?
Soap, water and a soft cloth. A glass cleaner or grease cutter can also be used.
What should be used as a trim or an edge treatment?
Aspect should be treated like any other tile. Clear or colored caulk is a good option. Caulk can be
painted to match wall color if preferred. Wood, plastic or other types of trim also work well
depending on your preference and abilities.
Can Aspect be applied to a working surface or to the floor?
These applications are not recommended, as the rubbing could potentially scratch the surface of
the panel.
What is the life expectancy of the Aspect Tile?
Aspect tiles and panels will last well-beyond the lifetime of your kitchen, bath or wall project.
The tiles and panels are virtually indestructible under normal use.
Does the surface of an Aspect tile scratch easily?
Not easily, but it can be scratched like any coated metal surface.
When starting a project, would I work from one side to the other, or from the center out?
Working from the center out would balance the working area and ensure your largest tiles in the
middle of your space. This could be important when a designer pattern is used. However, you
can start at one end and work to the other.
If I wanted to remove a tile (or a few), how would I do so and what would I use?
Start by applying pressure slowly underneath the 3’’ side of a tile and increase pressure lifting
the tile up. Note: Be careful not to damage the adjacent tile. A 1” putty knife or similar tool that
applies even pressure across the surface upon which you are prying is recommended. Note:
subsurface material like drywall may be affected due to the aggressive nature of the tile adhesive
which may require touch up or priming prior to replacing the tile.