User`s manual

1. Connect the video and audio outputs of analog camera to the video server. If the

analog camera is a PTZ device, connect the RS-485 for the remote PTZ control.

2. Connect the cables of Digital I/O, Video output and Audio output if you want to use

these functionalities.

3. Connect the wireless antenna for Wireless model.

4. Connect Ethernet cable for network connection.

5. Connect power adapter to turn on the video server.

6. Set up the network configurations according to the network environment. For further

explanation, please refer to Network Configuration chapter.

7. After finish the configuration for the very first time, if you want to use wireless network,

plug out the Ethernet cable.

I/O Connections

I/O terminal connector:

 4 sets of Digital Input (Alarm In + GND) – The digital inputs for connecting devices

that can toggle between an open and closed circuit, such as PIRs, door/window

contacts, glass break detectors, etc. When a signal is received the status changes

and the input becomes active.

 4 sets of Relay Output (N.O. + COM or N.C. + COM) –The output to Relay switch

of the alarm device such as LEDs, Sirens, etc.

Alarm In

Relay Out