User`s manual

43
: Click the icon to select the channel for configuring the
motion areas.
Set the Area: To set up the motion area, click [Draw Area] button on Set Arearow,
and then use mouse to drag the area on the video.
Clear the Area: To clear the motion area, just click [Clear Area] button.
Adjust the Sensitivity: To adjust the sensitivity of detection, select the level from the
pull-down list.
Activate Motion Detection: To activate the motion detection of each channel, enable
the [Detect CH] check box
Actions when Motion Detection is Trigger: Select what actions will be taken once
the motion detection is triggered for each channel.
E-mail: When the motion detection is triggered by this channel, send the
recorded video or snapshot to the specific mail address.
FTP: When the motion detection is triggered by this channel, send the
recorded video or snapshot to the specific FTP site.
To set the mail account and FTP site, please refer to Configuration Event
Handling Mail&FTP page.
Save to SD Card: When the motion detection is triggered by this channel,
record the video or snapshot into the local SD card.
Out1 / Out2 / Out3 / Out4: When the motion detection is triggered by this
channel, turn on the Relay Output 1, 2, 3 or 4.
E-Mail Subject: The subject of the E-mail will be sent.
Detection Interval: The interval time between multiple detections. For example, if the
time set to 10 seconds, when the motion detection is triggered at time 10H:05M:10S,
the next detection will be accepted after 10H:05M:20S. The detections between
10H:05M:10S to 10H:05M:19S will not be accepted.
Recommendation of Motion Detection Area
To ensure the Motion Detection works well, and avoid unnecessary trigger, please
follow the rules to draw the Motion Detection Areas:
The moving object larger than the 50% of the Motion Detection Area, it will be
detected, and the Motion Detection is triggered.
The moving object smaller than the 50% of the Motion Detection Area, it will not