User`s manual

In RTSP mode, you may use TCP and UDP for connecting. TCP connection uses

RTSP Port. UDP connection uses RTP Start and End Port.

UPnP Setting

UPnP: Enable or disable the UPnP protocol.

This device supports UPnP, if the UPnP service is enabled on your computer, the

device will automatically be detected and a new icon will be added to “My Network

Places”.

Note: UPnP service must be enabled on your computer.

The Windows Vista and Windows 7 have enabled UPnP service by default. To activate

UPnP service in Windows XP, please follow the procedure:

1. Open the “Control Panel” from the “Start” menu.

2. Select “Add/Remove Programs”.

3. Select “Add/Remove Windows Components” and open “Networking Services”

section.

4. Click “Details” and select “UPnP” to setup the service.

5. The network device icon will be added to “My Network Places”.

6. You may double-click the network device icon to access it via IE browser.

Onvif Setting

This device supports Onvif standard, you can configure the following settings to

compatible with the NVC (Network Video Client) such as NVR or recording software:

Onvif Version: Select the version of Onvif standard, or disable the Onvif output.

Security: Enable or disable the Onvif security authentication.

RTSP Keepalive: If select “Enable”, when the NVC doesn’t send the command for

keeping the RTSP connection, this device will terminate the RTSP connection. If

select “Disable”, this device will always keep the RTSP connection. If the “Time-out”

error happens on NVC side, please disable this function.

After set up, click [Apply] to save the settings.