User`s manual

61
 Set Subnet Mask of Router, PC and video servers.
 Set Gateway of PC and video servers with the same IP address. The Gateway is the
IP address of router.
 Set the IP address of a valid DNS into video servers. An invalid DNS will cause the
domain name can’t be resolved and reached, such as email address.
 Configure the video servers with different RTSP port. Ex. assign Video Server1 with
port 554, and assign Video Server2 with port 555.
 To allow the video servers can be linked through Internet, set router’s NAT (Network
Address Translation), Port Forwarding or Virtual Server as following:
Video
Server
WAN Side LAN Side
Remark
Port Protocol IP Address Port Protocol
Video
Server 1
3081 TCP 192.168.1.200 80 TCP Port for Web page
554 TCP 192.168.1.200 554 TCP
Port for Video and
Audio
Video
Server 2
3082 TCP 192.168.1.201 80 TCP Port for Web page
555 TCP 192.168.1.201 555 TCP
Port for Video and
Audio
For example, if the IP settings have been configured as the above figure, the video
servers can be linked with following addresses:
Clients in
Intranet
Video Server Link Address Remark
PC1
Video Server 1 http://192.168.1.200
Video Server 2 http://192.168.1.201
Client from
Internet
Video Server Link Address Remark
PC2
Video Server 1 http://60.220.20.250:3081
Video Server 2 http://60.220.20.250:3082
3G
Mobile
Phone
Video Server 1
With audio:
rtsp://60.220.20.250:554/3g
Without audio:
rtsp://60.220.20.250:554/3gx
Must enable “3GPP
Stream” in Configuration
 Video/Audio  Video
Format page