User`s manual

55
6. Network Configuration
A. Intranet Only
Connects to PC Directly
If you want to connect the video server to PC directly for the very first time setup, please
refer to the figure below for the connection.
 Connect the video server to PC with Ethernet cable. The video server equips an
Auto-MDI/MDIX network connector, you can use a straight or cross-over Ethernet
cable.
 Refer to Configuration  Network  Network page to configure the IP settings.
 Please make sure the IP address of PC and video server are in the same subnet. Ex.
192.168.1.2 and 192.168.1.210 have the same subnet.
 Set Subnet Mask of PC and video server.
 Clear the Gateway of PC and video server to empty.
For example, if the IP settings have been configured as the above figure, the video server
can be linked with following addresses:
Client Video Server Link Address Remark
PC Video Server http://192.168.1.210
PC
IP
Address: 192.168.1.2
Subnet Mask: 255.255.255.0
Gateway: (Empty)
Video Server
IP
Address: 192.168.1.210
Subnet Mask: 255.255.255.0
Gateway: (Empty)
Http
Port: 80
RTSP
Port: 554
Ethernet Cable
This device supports Auto
-MDI/MDIX,
you can use a straight or cross
-over
cable to connect these two devices.