Installation Instructions

LED Screw-base High Bay Lamp
1. Installation
It could be easily installed using a straight screwdriver . Use a flat-blade
screwdriver to unscrew the plug and remove the plug. And then. Choose
motion sensor to install and tighten.
Note: the motion sensor has no dialing code, and a remote control is needed
for adjustment. Please refer to the instruction for remote control adjustment.
2. Function
Adopted dual PD technology, HB01DMS-A/B is able to differentiate artificial light
brightness from natural light after installed inside the fixture, and automatically turn off
light when ambient brightness exceeds preset lux level
Light automatically on when ambient brightness is lower than pres
et lux level.
Within sufficient ambient brightness, light dims to100% when motion
detected. Light dims to stand-by level if no motion detected after hold time.
Light off when ambient lux level is higher than preset lux amount.
3. Warning
DISCONNECT POWER AT SERVICE ENTRANCE BEFORE CLEANING OR
SERVICING. ADD GRILLE CURRENT TO FAN CURRENT FOR TOTAL CURRENT
DRAW. INSTALL ONLY WITH MODELS INDICATED IN THE INSTALLATION
INSTRUCTIONS.
COUPEZ L’ALIMENTATION AU PANNEAU ÉLECTRIQUE AVANT LES TRAVAUX DE
NETTOYAGE OU D’ENTRETIEN. ADDITIONNEZ LA CONSOMMATION DE COURANT
DE LA GRILLE À CELLE DU VENTILATEUR POUR OBTENIR L’APPEL TOTAL DE
COURANT. S’INSTALLE UNIQUEMENT AVEC LES MODÈLES INDIQUÉS DANS LES
DIRECTIVES D’INSTALLATION.
FCCWARING
Any Changes expressly or modifications not approved by the party responsible
for compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:(1) This device may not cause harmful interference,