User's Manual

56
Flanger
Control knob Parameter Range Description
2 Preset 1-3 Selects preset template
3 [Rate] 0.02-10.0 Hz Controls the anger rate
4 [Depth] 0.0-128.0 Controls the anger depth
5 Oset +/- 180° Sets initial phase of eect relative to input
6 Feedback +/- 63 Feeds anger back into itself (positive or
negative polarity)
7 Mono/St Mono, Stereo Selects mono or stereo output
8 [Dry/Wet] 0.0-100.0% Blends unaected and aected signals
Rotary
Control knob Parameter Range Description
2 Preset 1-3 Selects preset template
3 [Lo-Speed] 0.02-10.0 Hz Sets speed of low rotor
4 [Hi-Speed] 0.02-10.0 Hz Sets speed of high rotor
5 Lo-Depth 0-127 Controls depth of low rotor
6 Hi-Depth 0-127 Controls depth of high rotor
7 Low/High -/+ 63 Volume balance between the low and high
rotors
8 [Dry/Wet] 0.0-100.0% Blends unaected and aected signals
Phaser
Control knob Parameter Range Description
2 Preset 1-3 Selects preset template
3 [Rate] 0.02-10.0 Hz Controls the rate of the phase modulation
4 [Feedback] +/- 63.0 Feeds phaser back into itself (positive or
negative polarity)
5 Depth 0-127 Controls the depth of the phase modulation
6 Phase 0-127 Adjusts lowest frequency point of phase
modulation
7 Oset +/- 180° Controls amount of phase oset relative to
input
8 [Dry/Wet] 0.0-100.0% Blends unaected and aected signals