Specifications
Table Of Contents
- Cover Sheet
- Table of Contents
- Notes on Safety
- Introduction
- Selecting the Type of Reference Value
- Representing the Reference Values in User Units
- Combining the Reference Values
- Available Reference Values
- Additional Functions
- Parameterizing the Speed and Torque Limits
- Additional Functions
- Fieldbus
- Used Parameters
- Global Presence
- Publication
- STÖBER Homepage
- STÖBER Product Range
Comfort Reference Value – 5th Generation of STÖBER Inverters
STÖBER
ANTRIEBSTECHNIK
5. Combining the Reference Values
KSW-23
Binary inputs
Signal Function Selector
Fieldbus
Image
Display
Parameter
Time ON Time OFF
Main reference
value select 0
D118.0 D211 Bit7 - -
Main reference
value select 1
D118.1 D211 Bit8 - -
Main reference
value select 2
The main reference value select signals
can be used to switch between different
main reference value sources during
operation (e.g., reference value external,
correction reference value or motor
potentiometer). The selection with the
main reference value selectors takes
priority over the setting in D30.
D118.2 D211 Bit9
D318
- -
Enable main
reference value
(edge)
D119 D211 Bit10 D319 D419.0 D419.1
Enable main
reference value
(level)
When the main reference value is
switched during operation, the change
must be accepted with an enable signal.
The enable can be edge or level-
controlled. To accept a switchover the
enable main reference value (edge)
signal must have a positive edge or the
enable main reference value (level)
signal must have a HIGH level.
D120 D211 Bit11 D320 D420.0 D420.1