Specifications

Comfort Reference Value – 5th Generation of STÖBER Inverters STÖBER
ANTRIEBSTECHNIK
11. Used Parameters
KSW-168
D.. Reference Value
Par. Description Fieldbus-
address
D127.1
Axis, OFF
r=1, w=1
preset ref decelerating source
Value range: 0 ... 0: Low ... 28
Fieldbus: 1LSB=1; Type: U8; USS-Adr: 04 1F C0 01 hex
267Fh
Array
1h
D127.2
Axis, OFF
r=1, w=1
preset ref decelerating source
Value range: 0 ... 0: Low ... 28
Fieldbus: 1LSB=1; Type: U8; USS-Adr: 04 1F C0 02 hex
267Fh
Array
2h
D127.3
Axis, OFF
r=1, w=1
preset ref decelerating source
Value range: 0 ... 0: Low ... 28
Fieldbus: 1LSB=1; Type: U8; USS-Adr: 04 1F C0 03 hex
267Fh
Array
3h
D128
Axis, OFF
r=1, w=1
Edge enable PR/FR source: After a switch of the preset reference values, fixed values, or
accelerating or decelerating ramps, the change must be accepted by an enable signal. The enable
is given when either a positive edge is determined for the signal edge enable PR/FR or a HIGH
level is determined for the signal level enable PR/FR.
The parameter D128 specifies the source for the signal edge enable PR/FR. The selections 0:low
and 1:high correspond to fixed signal levels. Das Signal edge enable PR/FR kann mit diesen
Auswahlen nicht verwendet werden. When the selection is 2:parameter, the control word D212
Bit14 is used as the source. The control word can be written via fieldbus.
Regardless of the selected source, the signal is indicated in D328. When the signal is to be
processed with time delay, a "switch on" delay can be parameterized in D428.0 and a "switch off"
delay in D428.1.
0: Low;
1: High;
2: parameter;
3: BE1;
4: BE1-inverted;
5: BE2;
6: BE2-inverted;
7: BE3;
8: BE3-inverted;
9: BE4;
10: BE4-inverted;
11: BE5;
12: BE5-inverted;
13: BE6;
14: BE6-inverted;
15: BE7;
16: BE7-inverted;
17: BE8;
18: BE8-inverted;
19: BE9;
20: BE9-inverted;
21: BE10;
22: BE10-inverted;
23: BE11;
24: BE11-inverted;
25: BE12;
26: BE12-inverted;
27: BE13;
28: BE13-inverted;
Fieldbus: 1LSB=1; Type: U8; USS-Adr: 04 20 00 00 hex
2680h 0h