Specifications
Table Of Contents
- Cover Sheet
- Table of Contents
- Notes on Safety
- Introduction
- Selecting the Type of Reference Value
- Representing the Reference Values in User Units
- Combining the Reference Values
- Available Reference Values
- Additional Functions
- Parameterizing the Speed and Torque Limits
- Additional Functions
- Fieldbus
- Used Parameters
- Global Presence
- Publication
- STÖBER Homepage
- STÖBER Product Range
Comfort Reference Value – 5th Generation of STÖBER Inverters
STÖBER
ANTRIEBSTECHNIK
4. Representing the Reference Values in User Units
KSW-15
Figure 4-11 Parameterization of the ratio "master/slave drive"
You can access page 2.4.1.A by clicking the button “Configuration of analog input”
(Konfiguration Analogeingang) (Figure 4-12). The interface of the master reference value
is parameterized on this page if the master reference value is supplied via an analog
input. When the master reference value is entered on the inverter by fieldbus, set D140 =
4:parameter.
Remember that the information in Figure 4-12 only applies when the analog input has
been selected. For details on the settings see the applicable parameter descriptions in
the bottom half of the Assistant.
Figure 4-12 Parameterization of the signal source for the master reference value