Specifications

Comfort Reference Value – 5th Generation of STÖBER Inverters STÖBER
ANTRIEBSTECHNIK
11. Used Parameters
KSW-159
D.. Reference Value
Par. Description Fieldbus-
address
D110
Axis, OFF
r=1, w=1
Torque switch source: The signal torque switch can be used to switch between the absolute
torque limits torque limit and torque limit 2. Torque limit is active with a low level. Torque limit 2 is
used for a high level.
The parameter D110 specifies the source for the signal torque switch. The selections 0:low and
1:high correspond to fixed signal levels. When the selection is 2:parameter, the control word D210
Bit10 is used as the source. The control word can be written via fieldbus.
Regardless of the selected source, the signal is indicated in D310. When the signal is to be
processed with time delay, a "switch on" delay can be parameterized in D410.0 and a "switch off"
delay in D410.1.
0: Low;
1: High;
2: parameter;
3: BE1;
4: BE1-inverted;
5: BE2;
6: BE2-inverted;
7: BE3;
8: BE3-inverted;
9: BE4;
10: BE4-inverted;
11: BE5;
12: BE5-inverted;
13: BE6;
14: BE6-inverted;
15: BE7;
16: BE7-inverted;
17: BE8;
18: BE8-inverted;
19: BE9;
20: BE9-inverted;
21: BE10;
22: BE10-inverted;
23: BE11;
24: BE11-inverted;
25: BE12;
26: BE12-inverted;
27: BE13;
28: BE13-inverted;
Fieldbus: 1LSB=1; Type: U8; USS-Adr: 04 1B 80 00 hex
266Eh 0h
D111
Axis, OFF
r=1, w=1
Master / slave switch source: When the signal master / slave switch source assumes the
value 1:active, the master reference value is processed (selector D140).
The parameter D111 specifies the source of the signal. The selections 0:low and 1:high correspond
to fixed signal levels. Control word D210 Bit11 is used as the source for selection 2:parameter. The
control word can be written via fieldbus.
Regardless of the selected source, the signal is indicated in D311. If the signal is to be processed
with a time delay, a "switch on" delay can be parameterized in D411.0 and a "switch off" delay in
D411.1.
NOTE
When the master reference value is executed in torque control, the drive changes to speed mode
when the signal is deactivated.
0: Low;
1: High;
2: parameter;
3: BE1;
4: BE1-inverted;
5: BE2;
6: BE2-inverted;
7: BE3;
8: BE3-inverted;
9: BE4;
266Fh 0h