Specifications

Comfort Reference Value – 5th Generation of STÖBER Inverters STÖBER
ANTRIEBSTECHNIK
11. Used Parameters
KSW-157
D.. Reference Value
Par. Description Fieldbus-
address
18: BE8-inverted;
19: BE9;
20: BE9-inverted;
21: BE10;
22: BE10-inverted;
23: BE11;
24: BE11-inverted;
25: BE12;
26: BE12-inverted;
27: BE13;
28: BE13-inverted;
Fieldbus: 1LSB=1; Type: U8; USS-Adr: 04 1A 80 00 hex
D107
Axis, OFF
r=1, w=1
Jog- source: When jog mode is enabled and the Jog - signal is active, the drive is accelerated
with the jog ramp D28 to the negated reference value selected in D135.
The parameter D107 specifies the source of the signal. The selections 0:low and 1:high correspond
to fixed signal levels. Control word D210 Bit7 is used as the source for selection 2:parameter. The
control word can be written via fieldbus.
Regardless of the selected source, the signal is indicated in D307.
0: Low;
1: High;
2: parameter;
3: BE1;
4: BE1-inverted;
5: BE2;
6: BE2-inverted;
7: BE3;
8: BE3-inverted;
9: BE4;
10: BE4-inverted;
11: BE5;
12: BE5-inverted;
13: BE6;
14: BE6-inverted;
15: BE7;
16: BE7-inverted;
17: BE8;
18: BE8-inverted;
19: BE9;
20: BE9-inverted;
21: BE10;
22: BE10-inverted;
23: BE11;
24: BE11-inverted;
25: BE12;
26: BE12-inverted;
27: BE13;
28: BE13-inverted;
Fieldbus: 1LSB=1; Type: U8; USS-Adr: 04 1A C0 00 hex
266Bh 0h
D108
Axis, OFF
r=1, w=1
Positive blocking source: When the signal positive direction blocking assumes the value
1:active, no positive reference value is processed. When the direction is blocked during operation,
the drive decelerates to a standstill with the respectively valid decelerating ramp.
When the signal is to be processed with time delay, a "switch on" delay can be parameterized in
D408.0 and a "switch off" delay in D408.1.
0: Low;
1: High;
2: parameter;
3: BE1;
4: BE1-inverted;
5: BE2;
6: BE2-inverted;
7: BE3;
266Ch 0h