User Manual

47
2 3 Feedback +/- 63 Feeds anger into itself (positive/negative
polarity)
2 4 Mono/St Mono, Stereo Selects output mode
Rotary
Page Control Parameter Range Description
1 1 FX Type
9 types (see Pre- and Post-FX (p. 46) Selects eect
1 2 [Hi-Speed] 0.02-10.0 Hz Sets high rotor speed
1 3 [Lo-Speed] 0.02-10.0 Hz Sets low rotor speed
1 4 [Dry/Wet] 0-100.0% Sets dry signal/eect blend
2 1 Preset 1-3 Selects template
2 2 Lo-Depth 0-127 Controls low rotor depth
2 3 Hi-Depth 0-127 Controls high rotor depth
2 4 Low/High -/+ 63 Low/high rotor balance
Phaser
Page Control Parameter Range Description
1 1 FX Type
9 types (see Pre- and Post-FX (p.
46)
Selects eect
1 2 [Rate] 0.02-10.0 Hz Controls phaser rate
1 3 [Feedback] +/- 63.0 Feeds phaser into itself (positive/
negative polarity)
1 4 [Dry/Wet] 0-100.0% Sets dry signal/eect blend
2 1 Preset 1-3 Selects template
2 2 Depth 0-127 Controls phase modulation depth
2 3 Phase 0-127 Adjusts lowest frequency point of
phase modulation
2 4 Oset +/- 180° Sets initial eect phase relative to
input
Lo-Fi
Page Control Parameter Range Description
1 1 FX Type
9 types (see Pre- and Post-FX (p. 46) Selects eect
1 2 [Cuto ] 160-20,000 Hz Filter cuto frequency
1 3 [Resonance] 1.0-12.0 Filter resonance
1 4 [Dry/Wet] 0-100.0% Sets dry signal/eect blend
2 1 Preset 1-2 Selects template
2 2 Filter Type Thru, PWBass, Radio, Tele, Clean, Low Selects lter model
2 3 Output - 6 / + 36 dB Gain compensation
2 4 Sampling 44,100-2,756 Hz Sets downsampling rate