Unit installation

BMB01 – Installation Guide
Recommended Installation Procedure
!
!
Please read and observe the instructions and guidelines in Section “4 Safety and Precautions”
(page 10) prior to installation. Failure to follow these instructions and guidelines may cause personal
injury and/or damage to the equipment.
1. If fitted, remove the connectors from both sides of the BMB01; see
Figure 1.
Figure 1 Removing the connectors
!
!
Care must be taken not to bend any pins in the BMB01 unit when removing and inserting
connector blocks. Male and female parts of the blocks must be square to each other at all times.
2. Remove the lid from the BMB01 by using a small screwdriver to depress the black clips at either side
of the unit and lifting the lid off; see
Figure 2.
Figure 2 Removing the BMB01 lid
DEPRESS CLIPS USING A
SMALL SCREWDRIVER.
Issue: 02 Complete, Approved
Page 4 of 12