Product manual

EAP01 - Product Manual
10 Safety and
Precautions
10.4 Unpacking and Handling
The equipment should be unpacked and
inspected immediately on receipt. If damage has
occurred please advise your carrier or supplier.
10.1 Environmental
It is advisable to retain the original equipment
packing in the event that the equipment ever
needs returning for service.
The temperature and humidity ranges shown in
the specifications for this product must not be
exceeded.
Ensure that the name and address of the
Authorised Distributor from whom you purchased
the unit is recorded on the “Service and Warranty”
page of this manual for future reference.
This equipment must not be installed in an area
that is subject to a corrosive atmosphere.
When installed in accordance to the instructions in
this document, the unit with door closed provides
IP65 ingress protection.
This equipment contains electronic devices that
are sensitive to electrostatic discharge. Please
take precautions to avoid damage to the
electronics by static electricity.
In the close proximity of some radio frequency
transmitters, the signal to noise ratio of this
product may be reduced. If this occurs, ensure
adequate system RF earthing or re-locate the
equipment or signal cables.
Advice on packing the product for return can be
provided by Application Solutions (Safety and
Security) Ltd.
10.2 ESD
This product contains static-sensitive devices.
Observe ESD precautions when working on the
equipment with the cover removed.
10.3 Electrical Safety
Always replace blown fuses in the supply to this
equipment with the correct type and rating.
Ensure power supply cabling is adequately rated.
Issue: 02 complete, approved
Page 46 of 52