Product manual

EAP01 - Product Manual
2. Power the unit on as described in Section “7.2 Powering the EAP01 On and Off” (page 36).
3. Fix the front panel assembly back in place using the 8 off M4 Allen screws.
4. Re-fit the door, see Figure 21.
Make sure that BOTH plastic bushes are tightly fitted to the door fixing holes in order to
preserve the unit’s IP rating.
!
!
Figure 21 EAP01 Door Installation
SLIDE THE
HINGE PIN
UPWARDS OR
DONWARDS BY
INSERTING A
SMALL
SCREWDRIVER
INTO ONE OF
THE HOLES IN
THE PIN
PLASTIC BUSHES
TIGHTLY FITTED
!
!
5. When finished, close and lock the door using the KABA key.
Issue: 02 complete, approved
Page 41 of 52