Product manual

EAP01 - Product Manual
7.4 Installing the EAP01 Front Panel/Electronics Assembly
The following procedure describes how to install the EAP01 Front Panel/Electronics Assembly into the back
box.
The following tools are required to replace the Front Panel/Electronics Assembly:
• A small flat bladed screwdriver.
• A 2.5 mm Allen key or driver.
Installing the Front Panel/Electronics Assembly:
1. Connect the new front panel assembly as follows, see Figure 20:
a. Plug the flying leads to the multi-way connectors on the electronics assembly.
b. Secure the flying leads to the front panel using the P-clip provided.
Figure 20 EAP01 Front Panel/Electronics Assembly
BS VERSION 5 OR LATER
BS VERSION < 5
P-CLIP
7-WAY CONNECTOR
6-WAY CONNECTOR
7-WAY CONNECTOR
6-WAY CONNECTOR
P-CLIP
FLYING LEAD
FLYING LEAD
L
DIP switch on microphone PCB is NOT used.
Issue: 02 complete, approved
Page 40 of 52