Product manual

EAP01 - Product Manual
7.3 Removing the EAP01 Front Panel/Electronics Assembly
For maintenance purposes the EAP01’s preferred Line Replaceable Unit (LRU) is the whole front panel and
the electronics assembly. Therefore the whole unit should be returned for repair as a single item. The
following procedure describes how to remove the EAP01 Front Panel/Electronics Assembly.
The following tools are required to replace the Front Panel/Electronics Assembly:
• A small flat bladed screwdriver.
• A 2.5 mm Allen key or driver.
Removing the Front Panel/Electronics Assembly:
1. Open the EAP01 door using the associated KABA key.
2. Remove the EAP01 door by compressing the hinge pin; see Figure 18.
This can be done by inserting a small screwdriver into the holes in the pin, and sliding it upwards or
downwards.
Take care to ensure that hinge pin’s plastic bushes in the back box are not loosened.
Figure 18 EAP01 Door Removal
SLIDE THE
HINGE PIN
UPWARDS OR
DONWARDS BY
INSERTING A
SMALL
SCREWDRIVER
INTO ONE OF
THE HOLES IN
THE PIN
PLASTIC BUSHES
TIGHTLY FITTED
!
!
3. Remove the EAP01 front panel assembly by removing the 8 off M4 Allen screws.
4. Power the unit off as described in Section “7.2 Powering the EAP01 On and Off” (page 36).
Issue: 02 complete, approved
Page 38 of 52