Product manual

EAP01 - Product Manual
12. Ensure that the power supply disconnect terminal is toggled on, if provided, as shown in Figure 8.
The power supply disconnect terminal is provided as standard on EAP01 Build Standard version 4A or
later.
Figure 8 Power Supply Terminal
BACK BOX
FIELD CABLING
+24 V INPUT – TERMINAL 5
DISCONNECT LEVER
(TOGGLED ON)
13. A baffle plate is provided as standard on EAP01 Build Standard Version 5 or later for protecting the
drainage hole on the bottom of the back box.
If the baffle plate is provided, and the cable entry is not through the bottom of the back box, fit the
baffle plate into the back box, as shown in Figure 9.
Figure 9 EAP01 Baffle Plate Installation
Plate orientation
OR
Plate position
after installation
OR
Plate position inside the
back box
(transparent side view for
illustrative purposes)
1. Insert the plate
into the back box
observing plate
orientation.
2. Rotate the plate.
3. Fit the plate
underneath the
back box front
edge at the bottom.
4. Drop the plate.
It will easily fit to
the back box
bottom.
Issue: 02 complete, approved
Page 17 of 52