Product manual

EAP01 - Product Manual
3. The EAP01 front panel/electronics assembly is normally supplied disconnected from the back box in a
separate box. When the EAP01 electronics/front panel is supplied fitted to the back box it must be
removed from the back box as follows:
a. Remove the EAP01 front panel assembly by removing the 8 off M4 Allen screws.
b. Disconnect the EAP01 front panel assembly by unplugging the flying lead from the multi-way
connectors on the electronics assembly, and undoing the cable loop P-clip; see Figure 5.
Figure 5 Front Panel/Electronics Assembly
BS VERSION 5 OR LATER
BS VERSION < 5
P-CLIP
7-WAY CONNECTOR
6-WAY CONNECTOR
7-WAY CONNECTOR
6-WAY CONNECTOR
P-CLIP
FLYING LEAD
FLYING LEAD
L
DIP switch on microphone PCB is NOT used.
c. Store the front panel assembly, door and fixing screws safely.
Issue: 02 complete, approved
Page 14 of 52